Isolation valve location for starboard water wing tank

Welcome Back Forums House Systems Fresh Water Plumbing Isolation valve location for starboard water wing tank

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #26060
    Czarina Blue
    Participant

    Can any one enlighten me as to where I might find the isolation cock for the starboard wing tank (fresh water)? The owner’s handbook marks it as being more or less where the battery box is, ie the starboard side of the engine cavity, but I can find no evidence of a valve there. Any help would be appreciated. Currently my two tanks link, when the lower keel tank is full the pressure causes the wing tank to fill, and when that is full, the overflow into the galley sink begins to run.
    Thanks, Duncan

    #26065
    Richard Garlant
    Participant

    Hi Duncan

    I’m not sure if this isn’t an installation ordered by a previous owner.

    We only have the lower keel tank.

    Unless Latorchee is the odd one out.

    Richard

    #26067
    Czarina Blue
    Participant

    Thanks Richard,

    It’s true that in the original brochure it is marked as an option.

    Cheers

    Duncan

    #26076
    racepassage
    Participant

    Hi Duncan,
    In my search for a air vent return hose (exhaust leak post) looked for the stbd wing tank isolation valve.
    Found the stem valve (see pic) under battery box at aft end between after battery box support and after transverse bulkhead.
    Only used the wing tank when offshore cruising as inner liner affected by blisters and, after a while, the water had a ‘funny’ taste.I didn’t grow horns though so used the water as a last resort.
    The boat is No. 117 fitted out for West Coast Canadian owner so if you don’t have a valve this may be a factor.
    Good hunting-Roger.

    #26079
    Czarina Blue
    Participant

    Brilliant Roger, I will hunt it out when I’m back on board on Thursday, hopefully it will be the same for mine, no 110. Thanks.Duncan

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.