Nick 38 zinc anode needed

Welcome Back Forums Deck and Hull Hull bottom and topsides Nick 38 zinc anode needed

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #25829
    Sailornick38
    Participant

    Seeking information on the zinc anode on the hull of my 38. Measurements are 15″ long X 1 3/4″ wide and 1/2″ deep. Would anyone have information on a supplier in the US. Seems like the last one lasted 6 years. It would be most helpful If I knew where I can locate another bar of zinc. If my memory is correct there was an eight or nine inch piece of scrape which indicates the supplier sold them a two foot bar. naumangl@triad.rr.com or 336 693 5979

    #25830
    Van
    Participant

    We’re based in Seattle. We’ve not found off the shelf zincs to fit so we have had to get them custom made.

    Look for a zinc plate (eg Fisheries Supply, 12″ x 1″ thick x 6″ wide). We had a shipwright cut these into bars 1.75″ wide to fit the width of the slots. To fit the bolts, have them drill one hole and one slot about 1″ long to make the fit easier. We also replaced the original bolts with longer ones to accept thicker zincs. BTW, shipwrights here charge way too much for shop time!

    Note, we are also able to use a thicker zinc because we counter sink the bolt holes in the zinc to allow us to get the bolts and lock nuts on, and still have the thick plates. I wish we had put longer bolts in to avoid the need for the counter sink.

    Hard to believe your plate lasted 6 years. Ours, made with thicker plate, last about 2 years. Our hull #126, can only take a 12″ long zinc, not 15″.

    Good luck,

    Van

    #25849
    Sailornick38
    Participant

    Here is the contact information that I used to locate the Zinc Raga needed:
    Ollie Robinson Sales Executive
    Email: orobinson@mgduff.co.uk
    MGDUFF International Ltd.
    Tel: 00 44 [0] 1243 533336
    http://www.mgduff.co.uk
    sales@mgduff.co.uk
    1 Timberlaine Estate,
    Gravel Lane,
    Quarry Lane,
    Chichester,
    West Sussex, PO19 8PP

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.